4/13/2024 0 Comments Enroute 4 driver speeds![]() ![]() The default units can be restored at any time by selecting the Use Defaults button. As described above, it is not recommended to change these units. These are units set by the manufacturer that are expected by the machine controller. Above the Material refers to speeds moving between toolpaths and Within the Material refers to speeds when cutting material.ĭefault Z axis speed moving in and out of cut.Ī minimum dwell time after entering the material to allow the tool to clear chips before beginning a cut. Spindle Speedĭefault spindle speed to use if no spindle speed is specifiedĭefault feed rates the machine moves in the X and Y axis if not specified in toolpath output. It is not recommended to change the units. The units in this category are defined by the manufacturer based on the units used by the controllers. These values are set by the manufacturer and it is not recommended to change them. Values in this category are limited by the machine capabilities so that it is not possible to define a speed that the machine is not capable of. Machine height (typically the Y axis dimension) Machine width (typically the X axis dimension) ![]() Parameters Driver DescriptionĪ brief description of the driver, such as the model of the machine or the type of driver The Current Driver list shows drivers that have been marked as active if the driver for a specific machine is not shown open the Active Drivers dialogue and add it to the list of active drivers. In the Machine Drivers dialogue, select the driver to configure from the Current Driver list. The driver or post processor interprets the output from EnRoute and translates it into a format that can be recognized by a specific machine. Machine Drivers are also referred to as Post Processors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |